House pads and site works across the Waikato
House pads, building platforms, cut and fill and hardfill, set out with grade control and compacted to spec. Your engineer signs it off, your builder starts on time.

Who builds house pads and site works in the Waikato?
Trident Earthmoving builds house pads, building platforms, shed pads and site works across the Waikato and Taupō. We strip topsoil, cut and fill to the engineer's design level using grade control, compact hardfill in layers with a roller, and hand over a platform ready for boxing, with cut, fill, hardfill and cartage priced separately so you can see where the money goes.
What builders need from us
A pad is a boring part of a build until it is wrong. Then it holds up the concrete, the inspection and everyone behind it.
What a builder actually needs is a pad at the right level, compacted properly, on the day it was promised. That is the job, and most of it comes down to accurate set out and not cutting corners on compaction.
Set out with grade control
Levels come off the model rather than off pegs and a string line. What the engineer specified is what ends up on the ground, which keeps the inspection straightforward and your programme intact.
Compacted, not just filled
Hardfill goes in in layers and gets rolled with a twin drum roller. A pad that was filled in one lift and driven over once will find you out later, usually after the slab is down.


Pads at the level they should be
We strip topsoil, cut and fill to design level, place and compact hardfill, and hand over a platform ready for the boxing. Levels are set with grade control off the model, so what the engineer asked for is what is there.
We also do the rest of the site works around a build: shed and tank pads, sand pads, service trenching, ground levelling and reinstatement once the build is done.
How a house pad job runs
- Get the drawings. Levels, footprint and any geotech requirements before we price.
- Quote the scope. Cut, fill, hardfill and cartage, clearly separated.
- Strip and cut. Topsoil off and stockpiled, then cut to level.
- Fill and compact. Hardfill in layers, rolled and tested where the job requires it.
- Hand over. Platform at level, ready for your boxing crew.
What does a house pad cost?
Pads are priced on how much material has to move and where it ends up. The footprint matters less than the ground it sits on. These are the things that move the number:
- How much cut and fill. A flat site is a strip and a roll. A sloping site means cutting into the bank and building the low side back up, which is a different job entirely.
- What the geotech report asks for. Hardfill depth, compaction targets and whether testing is required all come off the report, not off us.
- Where the spoil goes. Spoil that can stay on the property is far cheaper than spoil that has to be carted off and disposed of.
- Hardfill and cartage. How much imported material the pad needs and how far it has to come.
- Access. A tight subdivision lot with one way in and out works slower than an open site.
We price off the drawings and the geotech report, with cut, fill, hardfill and cartage separated so your QS can check the numbers line by line.
Where we work
Based at Whakamaru, we cover Taupō, the South Waikato, Waipā, Hamilton and out to Rotorua and the King Country. Here is the patch, and what we tend to see on the ground.
Common questions
Still not sure? Give us a call and we will talk it through.
Yes. We build to the drawings and levels supplied, and we run grade control so the finished level matches what was specified rather than being close enough. That keeps the inspection straightforward and your programme intact.
Yes. Hardfill goes in in layers and gets rolled with a twin drum roller. Where the job requires compaction testing we work in with whoever is doing it. A pad filled in one lift and driven over once will find you out later, usually after the slab is down.
Contact us
Tell us what you are dealing with and we will come and size it up.











